Käytämme evästeitä sivuston kehittämiseen. Hyväksytkö analytiikkaevästeet? Lue lisää
Volvo 850, C70, S70 and V70 first generation — engine, suspension, electrical and body repairs.
You need 10, 12, and 30 mm sockets, a short T45 Torx head, and short and long extensions for the wrench. Additionally, a nail or pop rivet suitable fo...
S60 gasoline: 2001–2004: 160,000 km or 4 years 2005–2006: 180,000 km or 4 years 2007–2010: 180,000 km or 10 years S60 diesel: 2001–20...
1. Open the plastic cover on the throttle body (Torx screw), pull the cover toward the front and remove it. 2. Open the clamps (3 pcs) at the air filt...
1. Lift the front of the car (on ramps or with a jack). 2. Drain 3–5 liters of coolant from the driver's side radiator drain plug. 3. Disconnect the u...
Injector size, color, and pressure: 200 cc = yellow, 3.0 bar 310 cc = orange, 3.0 bar (T-5R, part no. 0 280 150 785) 315 cc = red, 3.0 bar...
The air pump pumps additional air to the catalytic converter for a couple of minutes after starting to reduce emissions. The noise is usually caused b...
When installing cams in the upper cover: on the intake side at the driver's side end, the lobe should be above the cover bottom level, and on the exha...
The most common cause is poor solder joints on the ABS control module (ECU box), not a faulty sensor. Symptoms: error code 'weak signal' even though s...
MSA15.7 is the diesel control unit for the Volvo 2.5 TDI engine (D5252T). A fault code is recorded when the control unit detects a failure in the inta...
The bearing alone cannot be replaced as the hub is an integral part of the bearing assembly. However, hub replacement is straightforward. Remember to ...
Start from the parking brake lever: recline rear seats, pull parking brake up, shift into neutral. Remove side panels, center console (4 bolts) and pa...
1. Remove shock absorber top bolts (3 nuts from inside the car). 2. Remove shock absorber bottom attachment. 3. Jack up the suspension arm so the shoc...
1. Loosen the top nut (6) one turn before fully removing the shock absorber. 2. Remove drag link from shock absorber. 3. Remove shock absorber 2 botto...
Tools needed: grinding discs (115 mm), pair of C-clamps, flat pry bar. 1. Completely remove the rod between the bushing and the firewall. 2. Saw the ...
Nivomat shocks are noticeably thicker than standard shocks (about 80 mm vs. the narrower standard size)....
1. Lift front end with jack, place on axle stands firmly — higher is better. 2. Remove front wheels, remove stabilizer bar drag links. 3. Open steerin...
1. Remove the wheel and loosen the drive shaft hub nut. 2. Pry down the lower control arm and disconnect it from the ball joint. 3. Tap the drive shaf...
Yes. Often the boots are torn even though the struts are in perfect working order. A new boot stretches surprisingly much....
1. Pry down the lower control arm and disconnect it from the ball joint. 2. Turn the wheel carrier backward. 3. Lift the drive shaft onto the brake ca...
CEM (Central Electronic Module) is the central electronic control module that controls the CAN bus, door locking, alarm, headlights, fog lights, turn ...
VDO instrument cluster: reset by pressing a button on the cluster. Yazaki instrument cluster (850 1994–1995): reset button is located on the left side...
Relays are centralized in two locations: 100-relay box: in the engine bay at the bottom of the windshield 200-relay box: inside the dashboard ...
The 850 central lock controls ground, so choose negative control. Suitable control wires are found in the driver's footwell behind the kick panel: ...
1. Turn the ignition key 5 times: OFF→ON→OFF→ON→OFF→ON→OFF→ON→OFF→ON. Leave key in ON position (position II, don't start engine). 2. Within 5 seconds,...
Bulb list: Instrument cluster: 4x T10 (W5W) — fits directly Instrument cluster computer: 3x T5 (W1.2W) — fits directly Light control + oth...
A worn ignition switch base causes keys to wobble and feel loose. After replacement, the ignition switch feels solid again. The base from Volvo costs ...
Replace the rubber bushings at the shifter cable end (transmission side) with bearings. A bearing number 608 (dimensions 8×22×7 mm) fits directly in p...
You'll need a helper to support the tailgate. 1. Open round plastic covers from the interior light panel edges and T25 Torx screws. 2. Open T25 Torx ...
Assumption: license plate panel/opener system is removed from the car. 1. Remove C-clip from lock cylinder end (flies far easily). 2. Lift black plas...
1. Slide the front marker light outward by hand. 2. With a long flat-head screwdriver between the marker and light — wedge the screwdriver between the...
1. Carefully pry the mirror triangle cover off. 2. Remove the door panel. 3. Remove the window regulator clips and brackets from the glass. 4. If repl...
1. Remove floor mat and lower plastic trim above the pedals. 2. Remove black plastic covers on both sides. 3. Remove 2 screws from the sides and 1 scr...
Symptoms: climate control works but cold air adjustment doesn't function properly. The setting lever on the driver's side responds only at extreme pos...
1. Power OFF, pressure switch connector disconnected. 2. Measure resistance between pressure switch terminals — should be 0 ohms. 3. If not, proceed t...
1. Route electrical kit wires under vehicle to engine compartment (use rigid wire as guide). 2. Install proper grommet for passage. 3. Remove left car...
Search Volvo forums in seconds
Try HIPO free →